HP J2600A, Installation Manual

Page: 15 / 104

1. Check the Version of the SNMP Module.
The HP AdvanceStack 10Base-T Hub in which the HP AdvanceStack
Router 210 Module is to be installed must also have an HP J2603B Eth-
ernet SNMP Module installed. (The router module will be mounted on
the SNMP module.) This SNMP module must be the HP J2603
B version,
not the HP J2603 A version.
If an SNMP module is already installed and you are not sure which ver-
sion it is, you can determine it in either of two ways:
By removing the cover plate from the hub’s Expansion Slot and look-
ing at the module (refer to the procedure below).
By using HP Stack Manager to display the version of the module
(refer to the procedure on page 1-7).
Looking at the SNMP Module
1. Using a Torx T-10 or flat-blade screwdriver, loosen the two captured
screws holding the cover plate over the hub’s Expansion Slot, then
remove the cover plate. Note that the screws are spring-loaded and
will release outward when unscrewed far enough. Do not unscrew
them completely from the cover plate.
Loosen these two screws
Figure 1-1. Cover Plate Screws
In
s
ta
ll
a
ti
o
n
1
Installation
1. Check the Version of the SNMP Module.
1-5