Troubleshooting a Failure During Power-On
or Reset Self-Test
Router Self-Test LED On, Fault LED On
If, at the end of the self-test run after a power-on or reset, the Router
Self-test and Fault LEDs remain on, a message like the following appears
on the console. (If a console was not connected when the self-test was
run, connect a console and power-on or reset again.)
7, MK5025 Test
ERROR: MK5025 failed interrupt test, errcode = 00000001
SELFTEST FAILURE
A hardware problem was detected while running selftest.
To enter the selftest monitor, press ‘s‘. To attempt to
load operating code, press any other key.
If no key is pressed after 10 seconds, an attempt will
be made to load operating code.
If a qualified support person is available to operate the self-test monitor,
press
[s ]
to enter the self-test monitor. Otherwise, press
[Enter]
or wait 10
seconds to start an attempt to load the router’s operating code.
If the router boots (that is, if the router’s Copyright and Main Menu
screens appear), you may continue router operation. However, you
should record the error number and message and then call for
service from your HP dealer or service provider. It may be necessary
to download new operating code to the router.
If the router module does not boot, record the failure information
and call for service from your HP dealer or service provider. It may
be necessary to replace the router module.
Error number
Error message
Error procedure
T
r
o
u
b
le
s
h
o
o
ti
n
g
4
Troubleshooting
Troubleshooting a Failure During Power-On or Reset Self-Test
4-7
Summary of Contents for J2600A
