Table 20 Smart Array controller POST error codes
(continued)
Corrective action
Level
Description
Error
code
Contact your HP support representative
for assistance.
Critical
Slot z Drive Array Controller Failure (might be
followed by an exclamation point, and one or
more of the following:)
1783
•
[Board ID not programmed (replace ROMs or
replace controller)]
•
[I2C read error]
•
[Image checksum error]
•
[Inconsistent volume count]
•
[Inconsistent volume count (B)]
•
[Unexpected hardware revision]
•
[Incorrect EEPROM type]
•
[Init failure (cmd=##h, err=##h)]
•
[Command failure (cmd=##h, err=##h)]
•
[Self-test failure (ErrCode=####h)]
•
[I2C NVRAM reconfiguration failure]
•
[PCI bridge missing]
•
[PCI bridge disabled; check System ROM
version]
•
[Board ID not programmed]
Replace the indicated disk.
Informational
Slot z Drive Array Drive Failure The following disk
drive(s) should be replaced:
1784
Port 1I: Box 1: Bay 3
Follow the instructions in the error
message to correct the error condition.
Informational or
Critical
Slot z Drive Array not Configured (followed by
one of the following:)
1785
•
No drives detected.
•
Array Accelerator Memory Size Increased - Run
System Configuration Utility.
•
SAS Cable(s) Attached to Wrong SAS Port
Connector(s). Turn system power OFF and swap
SAS port connectors to prevent data loss.
•
Drive positions cannot be changed during
Capacity Expansion.
•
Drive positions appear to have changed. Run
Drive Array Advanced Diagnostics if previous
positions are unknown. Then turn system power
OFF and move drives to their original positions.
•
Configuration information indicates drive
positions beyond the capability of this
controller. This may be due to drive movement
from a controller that supports more drives than
the current controller. To avoid data loss turn
system power OFF and reattach drives to the
original controller.
•
Configuration information indicates drives were
configured on a controller with a newer
firmware version. To avoid data loss, reattach
drives to original controller or upgrade
controller firmware.
POST error codes
113
