Output Listings and Error Handling
eld Manual—527255-009
6-107
Error Messages
option does this if you specify the -update_code option. But you specified the -
update_code option without the
-alf
option.
Effect.
Fatal error (
eld
immediately stops without creating an output file).
Recovery.
If your intention is to run the
-alf
option on the millicode DLL then you
should have specified the -update_code option. In any other case, you should not
specify the -update_code option.
Cause.
You gave the
-alf
option, and the file that you gave with it was a program.
Usually, the
-alf
option only updates fixups within the data segment of a program or
DLL, because there shouldn’t be any in the code segment. However, the millicode DLL
within system library is a special case that has fixups to be done in the code segment.
The
-alf
option does this if you specify the -update_code option. But, since it is only
intended to be used in this special case, it is considered an error if you specify the -
update_code option and the file given to the
-alf
option was a program rather than a
DLL.
Effect.
Fatal error (
eld
immediately stops without creating an output file).
Recovery.
If your intention is to run the
-alf
option on the millicode DLL then you
should have correctly specified the name of the millicode DLL. In any other case, you
should not specify the -update_code option
Cause.
Each of the two files mentioned in the message defined symbols items of the
same name, as shown in the message. However, they were different types of
symbols, as shown in the message, and that is not allowed. For instance, the
message may say that one of the symbols was “code”, meaning a procedure, whereas
the other symbol was “data”.
Effect.
Fatal error (
eld
immediately stops without creating an output file).
Recovery.
Did you really intend to define symbols with the same name in each of
these two files, and have both definitions visible across separate compilations? If not,
change the name of one of them, or change the declaration of one of them so that it is
only visible within its own compilation. You cannot have a procedure and a data item
of the same name.
1591 The -update_code option is only allowed when rebasing a
DLL.
1595 Illegal duplicate definition of <symbol name>: the
definition in <filename> is <this type of symbol> and the
definition in <filename> is <this type of symbol>.
1596 Illegal duplicate definition of the procedure <symbol
name> in <filename> and <filename>.
Summary of Contents for eld
