HP E5200A, User Manual

Page: 43 / 152

1-29
Setting Up the Analyzer
To Insert or Remove an Interface Pod
1
Setting Up the
Analyzer
Caution You must always have two interface pods inserted in the analyzer while
it is operating. If your operations require only a single interface pod,
insert the blank interface pod (provided with the analyzer) into the
other port.
The two interface pods are necessary to maintain a balanced airflow for
cooling of internal components and to comply with EMC emission
standards.
To Remove an Interface Pod
When you remove an interface pod, make sure you store it in a dust-free
location that meets the environmental requirements listed in the
Setting
Up the Interface Pod guide. An electrostatic bag has been supplied for
storing each interface pod.
Note Before you use an optical interface pod, you should clean the optical connectors and
test cables. See the appropriate Setting Up the Interface Pod guide.
Note To avoid any possibility of eye damage, the laser is automatically turned off when you
insert or remove an optical interface pod.
Press on the clip underneath
the interface pod and firmly
pull the interface pod out of
the analyzer.