HP E5200A, User Manual

Page: 36 / 152

Setting Up the Analyzer
To Switch the Analyzer On and Off
1-22
To Switch the Analyzer On and Off
After you connect the analyzer to the computer, you can switch on the
equipment.
The analyzer takes approximately two minutes to run its self-tests and
switch on. While it is switching on, the Power LED flashes green, and if the
analyzer is booting from a PC or LAN, the Access LED flashes orange.
When the analyzer is on, the Power LED remains green and the Access
LED flashes orange intermittently. If the Power LED stays red, contact
your HP support representative.
To switch off the analyzer, switch off the power to the computer and the
analyzer. When you switch off, the analyzer performs a shutdown under
software control which makes sure all files are properly closed.
When you switch off the analyzer, the Power LED flashes green during
shutdown and then goes off.
Caution Make sure shutdown is complete before unplugging or removing the
power cables, or switching off power at the AC wall outlet.
1
Turn on the computer power switch.
2
Turn on the power
switch.