HP E-MSM310, Management And Configuration Manual

Page: 99 / 210

Working with VSCs
VSC configuration options
4-15
Select the access controller link to open the Security > Access controller page where
you can configure access controller options.
 If Use HP MSM Controller is disabled under General , then you can manually configure
the security filters as required using the following options.
 AP-name default gateway: The AP will only forward user traffic that is addressed
to default gateway assigned on the Network > Ports page (via DHCP, PPPoE, or
static addressing options).
 MAC address: The AP will only forward user traffic that is addressed to the
upstream device with the specified MAC address. Make sure that this device is set as
the default gateway for all wireless users. If not, user traffic will be blocked by the AP.
 Custom: Lets you define custom inbound and outbound security filters. To use the
default filters as a starting point, select Get Default Filters .
Filters are specified using standard pcap syntax with the addition of a few HP-
specific placeholders. These placeholders can be used to refer to specific MAC
addresses and are expanded by the AP when the filter is activated. Once expanded,
the filter must respect the pcap syntax. The pcap syntax is documented in the
tcpdump man page:
http://www.tcpdump.org/tcpdump_man.html
Placeholders
 %a : MAC address of the controller.
 %b : MAC address of the bridge.
 %g : MAC address of the default gateway assigned to the AP.
 %w : MAC address of AP wireless port.
Default wireless security filter definitions
The following filters are defined by default.