HP Designjet 230, Service Manual

Page: 167 / 268

8Ć33 Troubleshooting C4699Ć90000
Media not Loading. Make sure that the trailing cable
is positioned under the plastic tabs at the back of the carriage cover,
and not above them.
Otherwise, the following happens:
During plotter initialization, the trailing cable prevents the
carriage from reaching the leftĆhand stop, and all YĆaxis
references are shifted to the right.
During media loading, the line sensor on the carriage searches
for the right media edge at a position too far to the right, and
the plotter rejects the media.
The plotter does not park the carriage correctly in the service
station, so the cartridges are not correctly capped. The ink
dries in the nozzles, and the primer has no effect.
When you begin to load media and
push it into the plotter with too much force, too large a buckle
forms in the media. The roller is then not able to correctly grasp
the media and misaligns it. Instead, load the media so that the
sheet buckles only slightly.
If you push the media into the entry
platen too slowly, the media sensor instructs the roller to move
before the media has reached the roller. This can cause
misalignment of the media. Instead, push the media in briskly.
See the mediaĆloading guide C3190Ć90162 for more information on
the trick to loading media correctly every time.