•
Access level/Bay level:
All
•
Restrictions:
None
SET IPCONFIG
•
Command:
SET IPCONFIG {DHCP | STATIC} [<OA bay number>] [DYNAMICDNS] <ip address>
<netmask> [<gateway> [<DNS1address> [<DNS2 address>]]]
•
Description:
Configures IP settings for the Onboard Administrator to DHCP mode or static mode.
◦
◦
In
STATIC
mode, the IP address and Netmask are set to <
ip address
> and <
netmask
>
respectively. These settings take effect immediately. If the Gateway address or DNS
address or both are cleared, they are omitted. The Gateway and DNS addresses can
also be set by using the
SET OA GATEWAY
and
ADD OA DNS
commands.
◦
To configure in
STATIC
mode, use the following command format:
SET IPCONFIG STATIC [<OA bay number>] <ip address> <netmask> [<gateway> [<DNS1address> [<DNS2
address>]]]
◦
In
DHCP
mode, the IP address, Netmask, Gateway address, and DNS addresses are
obtained from the DHCP. This setting immediately takes effect. If
DYNAMICDNS
is specified,
then the DNS server is notified of the new IP address of the system when it is received
from the DHCP server.
◦
To configure in
DHCP
mode, use the following command format:
SET IPCONFIG DHCP [<OA bay number>] [DYNAMICDNS]
•
Access level/Bay level:
OA Administrator, OA Operator
•
Restrictions:
None
SET SNMP COMMUNITY
•
Command:
SET SNMP COMMUNITY {READ | WRITE} "<community name>"
•
Description:
Sets the community name for the read or write SNMP community. If a blank write community
name is given, then SNMP set commands are disabled until a non-empty community name is
given.
•
Access level/Bay level:
OA Administrator, OA Operator
•
Restrictions:
The write <
community name
> must be no more than 20 characters long, and the read
<
community name
> must be must be no more than 20 characters long.
◦
◦
All printable characters are valid.
66
Enclosure network configuration commands
