NOTE:
SERVER
is a valid alias for
BLADE
.
•
Description:
Enables the Onboard Administrator to provide IP addresses to the devices in the bays using
DHCP.
If you do not specify any bay numbers, then EBIPA is enabled for all bays.
DHCP traffic from iLO and the switch modules can no longer go outside the enclosure.
This causes a reset of the iLO, which causes it to attempt to get an IP address. The interconnect
is power-cycled.
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
Before using this command you must set up the EBIPA settings. This includes setting the initial
IP address, the netmask, and the default gateway.
REMOVE EBIPA
•
Command:
REMOVE EBIPA {BLADE|INTERCONNECT} DNS <ip address>
NOTE:
SERVER
is a valid alias for
BLADE
.
•
Description:
Removes the DNS server specified by the <ip address> from the list of DNS servers for either
BLADE
bays or
INTERCONNECT
bays
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
The <
ip address
> and must be in the form ###.###.###.###, where each ### ranges
from 0 to 255.
SET EBIPA
•
Command:
SET EBIPA BLADE { <IP address> <netmask> } | { NETMASK <netmask> }
| { GATEWAY <gateway> } | { DOMAIN <domain> } | { LOCAL } [ ALL |
<bay number> [{- | ,} <bay number>] ]
NOTE:
SERVER
is a valid alias for
BLADE
.
•
Description:
Sets EBIPA settings, including:
◦
Starting IP address
◦
Netmask
◦
Default gateway, primary or secondary NTP server (interconnects only)
◦
Domain name for the specified bay type
52
Enclosure Bay IP Addressing commands
