48
Configuration procedure
NOTE:
This example assumes that the RADIUS server runs iMC PLAT 5.0 (E0101) and iMC UAM 5.0 (E0101).
1.
Configure the RADIUS server (iMC PLAT 5.0).
# Add an access device.
Log in to the iMC management platform, click the
Service
tab, and select
User Access Manager
>
Access
Device
from the navigation tree to enter the
Access Device
page. Then, click
Add
to enter the
Add Access
Device
window, and perform the following configurations as shown in
:
a.
Set the shared key for authentication and accounting to
expert
.
b.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
c.
Select
Device Management Service
as the service type.
d.
Select
HP(A-Series)
as the access device type.
e.
Select the switch from the device list or manually add the switch with the IP address of
10.1.1.2.
f.
Click
OK
to finish the operation.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the switch (which is the IP address of the outbound interface by default) or the
IP address specified with the
nas-ip
or
radius nas-ip
command on the switch.
Figure 13
Add an access device
# Add a user for device management.
Log in to the iMC management platform, click the
User
tab, and select
Device Management User
from
the navigation tree to enter the
Device Management User
page. Then, click
Add
to enter the
Add Device
Management User
window, and perform the following configurations as shown in
:
a.
Add a user named
hello@bbb
and specify the password.
b.
Select
SSH
as the service type.
c.
Set the EXEC privilege level to 3. This value identifies the privilege level of the SSH user after
login and defaults to 0.
d.
Specify the IP address range of the hosts to be managed as 10.1.1.0 to 10.1.1.255.
