HP 9200C - Digital Sender, Getting Started Manual

Page: 23 / 254

Step 9. Install and configure the software
Install the software on the server that will be supporting the HP Digital Sending Software
(HP DSS) service. After installation, the HP DSS runs in the background as a service. It
starts automatically whenever the server is restarted.
NOTE The digital sender must be on and connected to the network in order to successfully
complete the software installation process.
Before you begin
During the software installation procedure, you are prompted to configure the digital-send
options. In order to complete this configuration, you need the following information:
● The software license key from the label on the software CD-ROM
● The host name or IP address of the SMTP e-mail server that will be used to send e-mail
from the digital sender
NOTE It is highly recommended that the SMTP gateway be located on your own local area
network. However, you may also configure your product for e-mail functionality even if your
mail services are provided by an outside Internet service provider (ISP) over a digital
subscription line (DSL).
● The host name or IP address of the LDAP server that will be used to retrieve e-mail
addresses (optional)
● The paths for any folders that are to be set up for the send-to-folder feature
● The host name or IP address of the digital sender
NOTE The installation steps that are provided here are for basic installation only. For more details,
and more advanced configuration information, see the
HP 9200C Digital Sender Support
Guide .
To install the software
1. Insert the HP DSS CD-ROM into the CD-ROM drive. When the setup program starts,
select
Install Now on the initial screen.
NOTE The setup program should start automatically. If it does not, browse to the CD-ROM drive
and run the SETUP.EXE file.
2. In the Choose Setup Language dialog box, select a language for the installation. The
setup wizard starts.
3. On the installation Welcome screen, click Next .
4. Accept the HP software license terms by clicking Yes .
5. Accept the default install location, or click Browse to select a different one.
ENWW Step 9. Install and configure the software 17
English