![background image](http://html.mh-extra.com/html/hp/635n-jetdirect-ipv6-ipsec-print-server/635n-jetdirect-ipv6-ipsec-print-server_administrators-manual_163681069.webp)
NOTE:
This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem.
Parameters for other subsystems such as IPX/SPX or AppleTalk are not affected.
To reset all parameters to factory default values, refer to
Troubleshooting the HP Jetdirect Print
Server on page 117
.
Moving to Another Network (IPv4)
When moving an HP Jetdirect print server that is configured with an IP address to a new network, make
sure that the IP address does not conflict with addresses on the new network. You may change the IP
address of the print server to one that can be used on the new network, or erase the current IP address
and configure another address after it is installed on the new network. See
Troubleshooting the HP
Jetdirect Print Server on page 117
for instructions to reset the print server to factory default settings.
If the current BOOTP server is not reachable, you may need to locate a different BOOTP server and
configure the printer to this server.
If the print server was configured using BOOTP, DHCP or RARP, edit the appropriate system files with
updated settings. If the IP address was manually set (for example, from the printer control panel or
Telnet), reconfigure IP parameters as described in this chapter.
Using the Embedded Web Server
You can use the embedded Web server on the HP Jetdirect print server to configure or view IPv4 and
IPv6 parameters. For more information, refer to
Embedded Web Server (V.36.xx) on page 61
.
Using the Printer Control Panel
When supported by the printer, HP Jetdirect EIO or embedded print servers provide a configuration
menu that can be accessed from the printer's control panel. Using this menu, you can enable or disable
network protocols and set basic network parameters.
NOTE:
For instructions on using the control panel for your printer, refer to your printer
documentation.
Depending on the HP Jetdirect print server and printer, configuration of selected IPv4/IPv6 and
IPsec networking parameters through the control panel is supported.
When accessing the HP Jetdirect menu from the printer's control panel, some TCP/IP network
configuration parameters that you can set include the following (see
HP Jetdirect Control Panel Menus
(V.36.xx) on page 169
for additional parameters):
●
IP host name
●
TCP/IPv4 settings
●
TCP/IPv6 settings
●
Other network protocols (IPX/SPX, AppleTalk, DLC/LLC)
●
Security settings
●
Link configuration settings
ENWW
Using the Embedded Web Server
59
Summary of Contents for 635n - JetDirect IPv6/IPsec Print Server
