![background image](http://html.mh-extra.com/html/hp/635n-jetdirect-ipv6-ipsec-print-server/635n-jetdirect-ipv6-ipsec-print-server_administrators-manual_163681045.webp)
DLC/LLC
dlc/llc-config:
(or
dlc/llc:
)
Enables or disables DLC/LLC protocol operation on the print server:
0
disables,
1
(default) enables.
NOTE:
HP Jetdirect 635n print servers: except for TCP/IP, network protocols are disabled by factory default.
Other Settings
link-type:
(For wired 10/100/1000T Ethernet) Sets the print server's link speed (10, 100, 1000 Mbps) and communication mode (Full-
or Half-Duplex). The available link-speed selections depend on the print server model. Selections are
AUTO
,
1000FULL
,
100AUTO
,
100FULL
,
100HALF
,
10FULL
,
10HALF
.
For
AUTO
(default), the print server uses auto-negotiation to configure itself with the highest link speed and communication
mode allowed. If auto-negotiation fails, either
100TX HALF
or
10TX HALF
is set depending on the detected link speed
of the hub/switch port. (A 1000T half-duplex selection is not supported.)
upgrade:
To configure one or more Jetdirect print servers with the name and location of a firmware upgrade file.
CAUTION:
Ensure that command parameters are properly entered and that the upgrade file is a higher version
than the currently installed version. The print server will attempt to upgrade when the upgrade file contains a
higher version than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP>
is the IP address of the TFTP server,
<Version>
specifies the firmware version of the upgrade file,
<Product Number>
specifies and must match the product number of the print server,
<Filename>
is the path and filename of the firmware upgrade file.
usb-mode:
Specifies the communication mode over the USB port on the HP Jetdirect print server.
●
Auto
(default): Automatically negotiates and sets the the highest communication mode possible for the attached
printer or device.
●
MLC
: (Multiple Logical Channels) An HP-proprietary communication mode that allows multiple channels of
simultaneous print, scan and status communications.
●
BIDIR
: A standard connection that supports bi-directional communications between the printer and print server. The
print server sends print data and receives status from the printer.
●
UNIDIR
: A standard connection in which data is transferred in one direction only (to the printer).
Table 3-2
TFTP Configuration File Parameters (continued)
ENWW
IPv4 Configuration
35
Summary of Contents for 635n - JetDirect IPv6/IPsec Print Server
