21091-0-0606
Page 21
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information on the side of the heater.
2. Check that gas supply to heater is on.
3. Push in gas control knob slightly and turn clockwise
to “OFF” position. Do not force (see below).
4. Wait five (5) minutes to clear out any gas, then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the
safety information on the side of the heater. If you do not smell gas, go to the next step.
5. Turn control knob counterclockwise
to pilot (*) position. Push control knob all the way in and hold it. Repeatedly push
the piezo ignitor button until the pilot is lit. Keep control knob pressed for fifteen (15) seconds before releasing. If pilot does not
light, repeat. If spark is not working, light the pilot with a match. The pilot can be located by looking through the rectangular open-
ing on the front cover.
NOTE:
It may be necessary to depress for thirty (30) seconds if this is the first time the heater is connected to
the gas supply. There may be air in the pilot line.
6. If the pilot light does not stay lit after several tries, turn gas control knob to “OFF” and call your service technician or gas supplier.
7. If knob does not pop up when released, STOP and call your service technician or gas supplier immediately.
8. To select the desired heating level, press down the control knob slightly and rotate counterclockwise
. Release downward
pressure on the knob while continuing to turn until the knob locks at the desired setting position. Do not operate between locked
position.
TO TURN OFF GAS TO APPLIANCE
Turn control knob clockwise
to the “OFF” position.
CAUTION:
Wait five (5) minutes before relighting the heater.
TO TURN OFF BURNER ONLY:
Turn knob clockwise
to the “PILOT” position. Pilot will remain lit.
CONTROL KNOB
IGNITION BUTTON
THERMOCOUPLE
PILOT
IGNITOR
Summary of Contents for HW075DVN-1
Page 23: ...21091 0 0606 Page 23 PARTS VIEW...
Page 27: ...21091 0 0606 Page 27 NOTES...
