Page 20
21091-0-0606
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal
injury, or loss of life.
A) This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B) BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C) Use only your hands to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not
try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D) Do not use this appliance if it has been under water. Immediately call a qualified service technician to inspect the heater and to
replace any part of the control system and any gas control which has been under water.
NOTE:
It is normal for the new heater to give off some odor the first time it is lit. This is due to final paint curing and to any un-
detected oil remaining from the manufacturing process. It is recommended that you operate your new wall heater for at least two
(2) hours the first time you use it.
ONCE THE UNIT IS IN OPERATION, CHECK ALL GAS CONNECTIONS WITH A SOAPY WA-
TER SOLUTION. CHECK THE TEST POINT PRESSURE; IT MUST BE 3.5" W.C. FOR NATURAL
GAS AND 10.0" W.C. FOR LP GAS.
Summary of Contents for HW075DVN-1
Page 23: ...21091 0 0606 Page 23 PARTS VIEW...
Page 27: ...21091 0 0606 Page 27 NOTES...
