INSTALLATION INSTRUCTIONS
❑
LEVELING THE RANGE
1. Remove the storage
drawer, broiler drawer
or kick panel.
2. Use a 3/16” open-end
or socket wrench to back
out both rear leveling
legs approximately two
turns.
3. Use a
open-end
or adjustable wrench to
back out the front
leveling legs two turns.
4. Install the oven
shelves in the oven and
position the range
where it will be installed.
5. Check for levelness by placing a spirit level or a
cup, partially filled with water, on one of the oven
racks. If using a spirit level, take two readings—with
the level placed diagonally first in one direction and
then the other.
6. Adjust the leveling legs until the range is level.
7. After the range is level, slide the range away from
the wall so that the Anti-Tip device can be installed.
❑
INSTALLING THE ANTI-TIP DEVICE
WARNING:
●
Range must be secured with an approved
Anti-Tip device.
●
Unless properly installed, the range could
tipped by you or a child standing, sitting or
leaning on an open door.
●
After installing the Anti-Tip device, verify that
it is in place by carefully attempting to tilt the
range forward.
●
This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
The use of this device does not preclude
tipping of the range when not properly installed.
●
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device
1. Mark the wall where the RIGHT
of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
Slotted
Head
Screw
2
/’
/
Anti-Tip
Device
I
I
“Marked Edge
/
/
/
of Range
2. Locate the outside edge of the device
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at
angle of 20 degrees from the horizontal. A nail or
awl may be used if a
is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you
will need a
1/4” x 1):”
bolt and a 1/2” ().1).
sleeve anchor, which are not provided.
the recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device.
bolts must be properly tightened as recommenced
for the hardware.
Wood Screw
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of
the rear surface unit openings and carefully
attempting to tilt the range forward.
WHEN ALL HOOKUPS ARE
MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF
POSITION.
MAKE SURE THE FLOW OF COMBUSTION
VENTILATION AIR TO THE
IS UNOBSTRUCTED.
38
Summary of Contents for RGB744GER
Page 46: ...NOTES 46 ...