Hoshizaki IM-100, Service Manual

Page: 53 / 129

49
Fig. 13
[Normal Position]
[Drain Position]
Bracket
Tank Drain
Pipe
[b] IM-100, IM-130, IM-160, IM-240
1) Close the water supply tap, and remove the
Inlet Hose.
2) Remove the Front Panels (Upper and
Lower).
3) Remove the screw located on the front of
the Water Tank.
4) Move the Tank Drain Pipe to the drain
position. See Fig. 13.
5) Push the Reset Switch in the Control Box, or
disconnect power source and reconnect
after 3 minutes.
6) The Water Pan will open, and then the
Actuator Toggle Switch will turn to the
“DEFROST” position in 40 seconds. (Click
sound will be heard.)
7) Blow out the water supply line immediately
after the Water Pan has opened.
Note: This procedure is necessary to protect
the icemaker from freezing up at
subfreezing temperature.
8) Unplug the icemaker with the Actuator Toggle Switch in the “DEFROST” position.
9) Move the Tank Drain Pipe to the normal position, and secure it with the screw.
10) Remove all ice from the Storage Bin, and clean the Bin.
11) Replace the panels in their correct positions.
12) Replace the Inlet Hose in its correct position.