HORN LHD6001+, Installation Manual, Page: 14 / 36

- 10 -
Telephone alarm
Oper
When there is alarm, the master controller dials the number, and the user will hear “Di Di Di”, and sounds after
2s, the sound will repeat for 5 times. And after 2s, the master controller hangs up. Before the hang up, user can
control the panel by telephone buttons. Press “0” means confirming the alarm, but no dial. But it will send alarm
to center station.
Before master controller hangs up, the users can operate the system by pressing telephone buttons. The
operations details are as below:
Press 3 to disarm when the system sounds “Di Di Di”;
After disarmed, press 1 to arm away, or press 2 to arm stay.
To turn off the siren, press 6 and press 7 to turn on the siren.
The siren will keep on for the time same with what set by command 29.
Note: Do not press any buttons on the telephone when voice alarming, or it will cause alarm message receiving failure. It will
stop the system to call to alarm just by turn off or turn on the siren, and it will be only stopped by pressing 0 button on
the telephone or disarm this system.
Remote Phone Operation
User can dial master phone of the system, and perform the operations: arm away/stay, disarm and field monitor
and hearing alarms. Operate as following:
User dials the number
→
the system picks up the phone, press#
→
input password
→
X
→
Press #
→
Hang up
X
＝
1: arm away
X ＝ 2: arm stay
X
＝
3: disarm
X
＝
6: siren off
X
＝
7: siren on. The siren will keep on for the time same with what set by command 29.
X
＝
0: hangs up
Dialing the master phone for more than ringing attempts set. The system will answer automatically and
announce the user with a sound “Di”. Then user presses “#+4digits user pa 1digit #”, the
system will operate corresponding commands. Operand has 4digits, 1 means arm away, 2 means arm stay,
3 means disarm, and 0 means hang up. For example, user password is 1234. To disarm the system, user can
press “# 1 2 3 4 #”after switching on the system. If the operations are performed correctly, “Di” will be heard
once, if the operations are performed incorrectly, “Di” will be heard twice. If password is wrong, user can input
password and operand again without inputting “#” in advance. The master controller will hang up if password is
input incorrectly three times or user does not press any key in 30s during the operation.
Note: Do not press any key during sounds “Di”, or message can not be received correctly. When dialing the master phone, the
users can continue operating the system without inputting the passwords again. When dialing the master controller,
after picked up, the users can arm, disarm all the zones or partially by inputting different passwords with #.