©2017, 2018, 2019 Horizon Global™ Corp. –
Printed in Mexico
Sheet 20 of 60
24964NP
06-24-19
Rev. C
12. Install Cable Ties
–
Measure
13” from center of vehicle and 2
-
1/4”
from forward edge of lower fascia and drill a ¼” hole through
fascia. Install cable tie (item 10) through hole, around hitch
crosstube, and tighten cable tie. Trim excess length from cable tie.
Both sides.
See Figure 3.
13. Reinstall Underbody Panel
–
Using original fasteners removed in
step 1.
11. Reinstall Taillights and Wiring
–
Using the original hardware, reinstall
taillights and reconnect wiring. Reinstall small access panels.
9.
Trim Lower Fascia
–
Using a tape measure, marker, and utility knife, cut a
5”
wide
X
3”
deep notch in the bottom center of fascia.
See Figure 3
. Using a utility knife,
carefully remove the (2) raised areas, used to connect plastic support brackets,
flush to inside surface of lower fascia.
See Figure 4.
10. Reinstall Lower Fascia
–
Reinstall lower fascia aligning tabs in lower fascia with
upper fascia and snap into place.
5”
3”
CUT
KIA MODELS
KIA MODELS
KIA MODELS
KIA MODELS
13”
2 ¼”