horiba LAQUA-PC1500, Instruction Manual

Page: 47 / 100

Conductivity Setup
29
● P1 COND Setup
Using P1 COND setup function of the meter, you can:
• Set cell constant
• Select conductivity unit
• Set calibration mode
• Set temperature coefficient
• Set reference temperature
• Erase calibration data
To set the conductivity functions, follow the procedure detailed below:
Prerequisites
• Switch on the meter.
• Press the
key to keep the meter in COND mode.
• Default cell constant value is 1.00 and one can set a value in between 0.07 to 13.00 .
• Default conductivity unit is set as S/cm . One can change the unit to S/m .
• Default auto calibration setup is set as ON , but to perform manual calibration, one need to
change the setup to OFF .
• Default temperature coefficient is 2.00%. One can set a value in between 0.00% to
10.00% .
• Default reference temperature is 25.0°C . One can set the value in between 15.0°C to
30.0°.
• Erasing previous calibration data is recommended for accurate calibration. Default setup is
NO but to erase the calibration data, one need to change the setup to YES .
To return to the measurement mode, press the key.
Note
Tip