10
Electrolyte Circulation System
7145240031 V1.1 (01.2013)
Figure 6: Inserted hard plastic tubes
Installation
The installation procedure in this section describes how to retrofit a HOPPECKE Electrolyte Circulation System
in an existing battery installation. It considers the default operating mode.
Before installation:
• Check if all required components have been delivered.
•
Note
: The Electrolyte Circulation System cannot be used with a recombination system (HOPPECKE AquaGen®
premium.top) simultaneously. Any recombination system plugs need to be replaced by the HOPPECKE
Labyrinth plugs (refer also to /3/).
• Please contact your HOPPECKE representative in case you want to use the Electrolyte Circulation System
together with an automatic water refill system.
Attention
Important note:
Before starting the installation procedure make sure that all safety precautions
(refer to chapter Safety precautions) are fulfilled. That includes:
1. Use insulated tools only.
2. Wear insulating rubber gloves and rubber shoes.
3. Wear protective glasses.
Important note:
Ensure that all electrical loads are switched off (separators, fuses, switches).
This must be carried out by qualified personnel.
Please consider that even after switching off all electrical loads metal parts of the battery are
always live. Never place tools or other objects on top of the batteries.
Step 1: Equip battery cells with air tubes
Summary of Contents for Electrolyte Circulation System
Page 1: ...Electrolyte Circulation System Installation and Operating Instructions...
Page 25: ...25 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...
Page 26: ...26 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...
Page 27: ...27 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...
