12
Electrolyte Circulation System
7145240031 V1.1 (01.2013)
Step 2: Connect all air tubes
The delivery contains a soft plastic air tube for connection between single battery cells and connection to the
pump- and control unit. This air tube needs to be cut into appropriate sections with a cutter knife or scissors.
Note:
The air tubes between the cells need to be as short as possible. Keep an adequate length of the air
tube for connection to the pump- and control unit (check distance to the location where the pump- and control
unit shall be mounted).
Put all ends of the soft air tube over the corresponding T-junctions which have been mounted on top of the hard
plastic tubes (refer also to Figure 11)
Note:
Make sure that all tubes are connected closely so that no air is leaking out of the system during pump
operation.
Figure 10: Connection between air tubes - I
Figure 11: Connection between air tubes - II
Summary of Contents for Electrolyte Circulation System
Page 1: ...Electrolyte Circulation System Installation and Operating Instructions...
Page 25: ...25 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...
Page 26: ...26 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...
Page 27: ...27 Electrolyte Circulation System 7145240031 V1 1 01 2013 Notizen...