HTTP/HTTPS
W
EB
GUI
–
W
EB
B
ROWSER
C
ONFIGURATION
I
NTERFACE
7052RC Network Management Server - V01.00
37 / 98
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
6.2.3 Entry or Changing Data
It is necessary to be logged on as one of the users described above in order input or change
data.
After an entry has been made the configured field is marked with a star ' * '. This means that
a value has been entered or changed but is not yet stored in the flash memory. It is necessary
to be acquainted with the symbols shown below in order to be able to save the configuration
or the changed value.
Meaning of the symbols from left to right:
No. Symbol
Description
1
Apply
Acceptance of changes and entered data
2
Reload
Restoring the saved data
3
Save
Fail-save storage of the data in the flash configuration
For permanent storage the value MUST be accepted by the Board with
Apply
and then saved
with
Save
.
However, this data is then lost when the
hopf
Base System is switched off or restarted.
If the data is only to be tested it is sufficient to accept the changes with
Apply
.
Changing Network Parameters
Modifications of the network parameters (e.g. IP address) are immediately
effective clicking on
Apply
to confirm.
However, the modifications are not permanently saved yet. This requires
to access the WebGUI with the new network parameters again and to
save the data with
Save
permanently.
