N
ETWORK
C
ONFIGURATION FOR
ETH0
VIA THE
B
ASE
S
YSTEM
7052RC Network Management Server - V01.00
31 / 98
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
5.2.1 Entry the Static IPv4 Address / DHCP Mode
Static IPv4 Address
In the upper line the selected board appears with its board number and IPv4 address of the
LAN interface ETH0. For configuration of a new IPv4 address the complete entry of the 4
groups of digits is necessary.
The IPv4 address is entered in 4 groups of digits configurable from 000 to 255. They are
separated by a dot (
.
). Input must be in the form of 3 digits (e.g.: 2
002).
An example of a complete entry would be as follows:
B . 7 0 5 2 N O . : 0 1 I P - A D R > 1 9 2 . 1 6 8 . 0 1 7 . 0 1 0 <
N E W I P - A D D R E S S > ~ ~ ~ . ~ ~ ~ . ~ ~ ~ . ~ ~ ~ <
In the case of an implausible entry (such as 265), an INPUT ERROR is sent and the complete
entry is rejected.
DHCP / Static IP Address Assignment
For the use of DHCP, the IP address, gateway address and network mask are all to be fully
set to
>000.000.000.000<
(invalid IP address).
All other addresses are interpreted as static IP addresses.
5.2.2 Entry the Gateway Address
The gateway address can be entered via the selection screen:
B . 7 0 5 2 N O . : 0 1 G W - A D R > 1 9 2 . 1 6 8 . 0 1 7 . 0 0 1 <
N E W G W - A D D R E S S > ~ ~ ~ . ~ ~ ~ . ~ ~ ~ . ~ ~ ~ <
The Gateway address can now be entered in the same way as the IP address, as described
in
Chapter 5.2.2 Entry the Gateway Address
.
5.2.3 Entry the Network Mask
The network mask can be entered via the selection screen:
B . 7 0 5 2 N O . : 0 1 N E T M A S K > 2 5 5 . 2 5 5 . 0 0 0 . 0 0 0 <
N E W N E T M A S K > ~ ~ ~ . ~ ~ ~ . ~ ~ ~ . ~ ~ ~ <
The network mask for LAN interface ETH0 can now be entered in the same way as the IP ad-
dress, as described in
Chapter 5.2.3 Entry the Network Mask
.
5.2.4 Entry the Control Byte
The Control-Byte is shown on the top line with the currently set values.
B . 7 0 5 2 N R . : 0 1 C O N T R O L - B Y T E 0 0 0 0 0 0 1 0
N E W C O N T R O L - B Y T E > ~ ~ ~ ~ ~ ~ ~ ~ <
For the purposes of manipulation, the individual bits of the new byte are to be entered on the
second line using
"0"
and
"1"
. The complete Control Byte must always be recorded and con-
firmed with the
ENT
key.
