Honeywell Solaris 7980g, User Manual, Page: 56 / 252

42 Solaris 7980g User Guide
command. After scanning the Read Time-Out bar code, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits on the Programming Chart , then
scanning Save . Default = 30,000 ms.
Presentation Mode
Presentation Mode uses ambient light and scanner illumination to detect bar
codes. When in Presentation Mode, the LEDs remain dim until a bar code is pre-
sented to the scanner, then the LEDs turn up to read the code. Scan the following
bar code to program your device for Presentation Mode.
Default = Presentation
Mode .
Presentation Idle Mode
When Presentation Idle Mode is selected, the scanner goes into idle mode (illumi-
nation dims) after the time interval set, during which there is no activity. Change
the Presentation Idle mode by scanning the bar code below, and then scanning
digits from the
Programming Chart , then scanning Save . The range is 0 to
3000000. The scanner will wake when an object is presented to the window or the
pitch or volume button is pressed.
Default = 10000 (10s) .
When Off is selected, no power saving is used and the scanner remains powered
on.
Note: In some conditions the scanner will switch between Presentation Idle Mode and
Presentation Sleep Mode according to ambient light level. This allows the scanner to
wake up in very dark conditions.
Note: This selection is unavailable when the Illumination Lights or LED Illumination -
Presentation Mode are set to off.
Read Time-Out
* Presentation Mode
Presentation Idle Mode
Off