44
Solaris 7980g User Guide
LED Illumination - Presentation Mode
If you wish to set the illumination LED brightness, scan one of the bar codes below.
This sets the LED illumination for the scanner when it is in Presentation Mode. (If
the scanner is triggered manually, the LED illumination will switch to the setting
for a manual trigger. See
Default = High.
Note:
The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scanner can “see” the bar codes.
Note:
The LEDs may turn off for a short time when the scanner detects low power.
Presentation LED Behavior after Decode
If you wish to dim the LEDs immediately after a bar code is decoded, scan the
LEDs
Off
bar code, below.
Default = LEDs On.
Off
Low
* High
* LEDs On
LEDs Off
Summary of Contents for Solaris 7980g
