Honeywell SmartLine, User Manual

Page: 21 / 130

2. Preparation and Quick Start
2.3. Transmitter Quick Start
Revision 2 SmartLine Wireles User's Manual 7
See section 4.5 for further provisioning details. This step may take several minutes,
depending on your network.
5. VERIFY that the transmitter appears in the wireless network, and is transmitting PVs. This
step may take several minutes, depending on your network.
a. Drag the transmitter icon from the selection panel to the map (optional)
b. Load the DD file (if not done previously)
i. Select the transmitter.
ii.
Press the maintenance “Templates” button.
iii.
Press “Load DD File”, and select the DD .zip file.
iv. Refresh the browser to re-load the WDM web interface. This will require to
log in again.
c. Activate the channel
i. Select the transmitter channel to activate
ii.
Press the Channel green “Activate” button
d. Configure the transmitter as desired using the property panel
i. Tag Name, Description, Display Tag, Routing assignment, Publication
frequency, Publication attributes, etc.
ii.
Ensure the press “Apply” after the changes, and wait for the changes to take
effect.
e. Configure the channel as desired using the property panel.
i. Name, Description, Process limits, Process Scale, etc.
ii.
Ensure to press “Apply” after the changes, and wait for the changes to take
effect.
6. INSTALL. If not done already, once the transmitter is verified to be functioning as expected,
it can be powered off and installed in the field. The provisioning key will remain.
7. CALIBRATE. If required, calibration should only be done after the transmitter is installed in
its final location. See section
4.6 .