Honeywell SmartLine, User Manual

Page: 52 / 130

4. Start up
4.1. Battery Power Option
38 SmartLine Wireless User's Manual Revision 2
4. Start up
4.1 Battery Power Option
Install/Replace batteries
WARNING
Risk of death or serious injury from explosion or fire.

When not in use the Battery Pack must be stored in a non Hazardous
Area

Do not change batteries in an explosive gas atmosphere.

The batteries used in this device may present a risk of fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 100°C
(212°F), or incinerate.

When installing batteries, do not snag the battery terminal on the clip or
the battery may be damaged. Do not apply excessive force.

Do not drop. Dropping the battery may cause damage. If a battery is
dropped, do not install the dropped battery into the transmitter. Dispose
of dropped battery promptly per local regulations or per the battery
manufacturer’s recommendations.
ATTENTION
Both batteries must be the same model from the same manufacturer. Mixing old
and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-
rechargeable), size D. No other batteries are approved for use in SmartLine
Wireless Transmitters.

Xeno Energy XL-205F

Eagle Picher PT-2300H

Tadiran TL-5930/s

Tadiran GmbH, SL-2780 (Not approved by FM or CSA)

Honeywell p/n 50026010-501 (Two 3.6V lithium thionyl chloride batteries)

Honeywell p/n 50026010-502 (Four 3.6V lithium thionyl chloride batteries)

Honeywell p/n 50026010-503 (Ten 3.6V lithium thionyl chloride batteries)