Honeywell Sensepoint XCD RTD, Technical Manual

Page: 39 / 68

Sensepoint XCD RTD Technical Manual SPXCDHMRTEN Issue 1
39
12.3 Faults and Warnings
The table below provides details of possible error.
Message Description Action
W-01 Calibration needed
The unit has not been calibrated for the
configured calibration interval
Calibration is necessary due to change
of sensor/gas type
W-02
Transmitter Temperature
limits exceeded
Use ‘

’ to clear when within limits
W-03
Alarm setting needs to be
configured
Re-configure alarm settings such that
upper alarm should not exceed user
configured scale
F-01 Internal I2C failure
Cycle power to detector. Replace
detector
F-02 Cell failure or Over range
Replace sensor or Check the input
signal wiring.
F-03 Significant zero drift Re zero/calibrate
F-04 Unexpected sensor fitted Replace sensor
F-05 EEPROM is corrupted
Reset transmitter. If fault still appear,
replace transmitter
F-06 Low supply voltage
Reset transmitter. If fault still appear,
replace transmitter
F-07 SRS processor failure
Reset transmitter. If fault still appear,
replace transmitter
F-08 RAM read/write fault
Reset transmitter. If fault still appear,
replace transmitter
F-09 Info. memory corrupted
Reset transmitter. If fault still appear,
replace transmitter
F-10 Code Memory corrupted
Reset transmitter. If fault still appear,
replace transmitter
F-11 DAC output failure
Check load resistor or sink/source mode
switch was configured properly
F-12 Heater failure
Reset transmitter. If fault still appear,
replace transmitter
F-13 Supplied voltage failure Check supply voltage. Replace detector
Table 7: Fault and Warning List