Honeywell N431X, User Manual

Page: 62 / 222

Output Sequence Editor
Enter Sequence
Default Sequence
Sequence Timeout
You may wish to set the maximum time between bar code scans in an out-
put sequence. If that maximum time is not met, the output sequence oper-
ation is terminated. Set the length (in milliseconds) for a timeout by
scanning the following bar code, then setting the timeout (from 1-65535
milliseconds) by scanning digits from the Programming Chart , then scan-
ning Save . Default = 5000 msec.
Sequence Timeout
Sequence Match Beeper
By default, the engine beeps when a sequence match is found. If you want the
engine to remain silent, scan the following
Sequence Match Beeper
Off bar code. Default = Sequence Match Beeper On.
Sequence Match Beeper Off
* Sequence Match Beeper On
Partial Sequence
If an output sequence operation is terminated before all your output
sequence criteria are met, the bar code data acquired to that point is a
“partial sequence.”
Scan
Discard Partial Sequence to discard partial sequences when the
output sequence operation is terminated before completion.
3-20