Honeywell N431X, User Manual

Page: 18 / 222

Menu Bar Code Security Settings
Honeywell engines are programmed by scanning menu bar codes or by
sending serial commands to the engine. If you want to restrict the ability to
scan menu codes, you can use the Menu Bar Code Security settings. Please
contact the nearest technical support office (see Limited Warranty on page 11-
1) for further information.
Setting Custom Defaults
You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before each
menu command or sequence you want saved. If your command requires scan-
ning numeric codes from the back cover, then a Save code, that entire
sequence will be saved to your custom defaults. Scan the Set Custom
Defaults code again before the next command you want saved to your custom
defaults.
When you have entered all the commands you want to save for your
custom defaults, scan the Save Custom Defaults bar code.
Set Custom Defaults
Save Custom Defaults
You may have a series of custom settings and want to correct a single setting.
To do so, just scan the new setting to overwrite the old one. For example, if
you had previously saved the setting for Beeper Volume at Low to your
custom defaults, and decide you want the beeper volume set to High, just
scan the Set Custom Defaults bar code, then scan the Beeper Volume High
menu code, and then Save Custom Defaults . The rest of the custom defaults
will remain, but the beeper volume setting will be updated.
Resetting the Custom Defaults
If you want the custom default settings restored to your engine, scan the Acti-
vate Custom Defaults bar code below. This resets the engine to the custom
default settings. If there are no custom defaults, it will reset the engine to the
factory default settings. Any settings that have not been specified through the
custom defaults will be defaulted to the factory default settings.
Activate Custom Defaults
1 - 4