turns off and stops scanning after a good read. If you scan
Do Not End
Character Activation After Good Read
, the laser remains on after a
good
read.
Default = End Character Activation After Good Read.
Do Not End Character Activation
After Good Read
* End Character
Activation After
Good Read
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode. Set
the length (in milliseconds) for a timeout by scanning the following bar code,
then setting the timeout (from 1-65535 milliseconds) by scanning dig-its from
the
Programming Chart
, then scanning
Save
.
Default = 5000 ms.
Character Activation Laser
Timeout
Character Deactivation Mode
If you have sent a character from the host to trigger the engine to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the
fol-lowing
On
bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to
termi-nate scanning.
Default = Off.
* Off
On
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
ASCII Conversion Chart
, page A-3, find the hex
value that represents the character you want to use to terminate scanning.
3-11
Summary of Contents for N431X
