Assembly
8
www.honeywellgenerators.com
HW5600C Portable Electrical Generator Owner’s Manual
Step 2: Install Wheel Axle and Wheels
1.
Install wheel axle brackets to frame using 16 mm long
full-thread hex bolts and serrated flange nuts.
1A.
Install pre-attached bracket to frame first.
NOTE:
Axle brackets are offset (one side longer than the other),
place with the short side up during installation.
1B.
Install other bracket to frame.
On each end of axle:
2.
Slide and push wheel onto axle until it fits snug
against washer.
3.
Slide a washer onto axle.
4.
Slide snap pin into pre-drilled hole until fully seated.
5.
Return generator to upright position (so that wheels
and leg supports are touching the ground).
To install wheel assembly, you will need:
Wheel axle (1)
M10 x 16 mm long full-thread hex bolts (4)
M13 serrated flange nuts (4)
Axle bracket
*
(1)
*
Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in accessory kit box.
Wheels (2)
M16 x 30 mm OD x 2.5 mm washers (2)
Snap pins (2)
10 mm open end wrench
†
Socket wrench with 13 mm socket
†
† Not included.
FIGURE 8:
Wheel Axle Attached to Generator
FIGURE 9:
Slide Wheel onto Wheel Axle
FIGURE 10:
Snap Pin Installation
Summary of Contents for HW5600C
Page 87: ... ...
