HW5600C Portable Electrical Generator Owner’s Manual
www.honeywellgenerators.com
7
Assembly
Step 1: Install Support Legs
1.
Place the generator on a flat, level surface.
2.
Stand at side of generator
opposite
recoil starter
handle. Grip frame; carefully pull up and push to tilt
generator backward.
3.
Gently set generator onto the recoil side or elevate
the generator by placing solid wood pieces under-
neath unit.
4.
Attach a rubber stopper to the bottom of each support
leg using a 28 mm long full-thread hex bolt and ser-
rated flange nut; tighten until securely seated.
5.
Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm long full-thread hex
bolts and serrated flange nuts; tighten until securely
seated.
To install support legs, you will need:
M8 x 28 mm long full-thread hex bolts (2)
M10 serrated flange nuts (2)
M10 x 16 mm long full-thread hex bolts (4)
M13 serrated flange nuts (4)
Brackets (2)
Rubber stoppers (2)
Socket wrench with 10 mm socket
*
*
Not included
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
FIGURE 5:
Tip onto Generator Recoil Side
CAUTION
FIGURE 6:
Rubber Stopper Attached to Support Leg
FIGURE 7:
Support Leg Attached to Generator
Summary of Contents for HW5600C
Page 87: ... ...
