Chapter 5 - Building ControlNet Trunk Cables
6. Slide the crimp ferrule over the three outer shields and connector base, until the ferrule meets the
shoulder on the connector.
7. To crimp the ferrule, position the crimp tool on the ferrule, as close as possible to the connector
base and ferrule meeting line. Press the tool tightly around the ferrule, until the crimp tool allows
release.
8. Pull the connector to verify that it is securely attached. If it is loose or comes off, remove it and install
a new one. Note: it may be necessary to cut back and re-strip the end of the cable if that is the
cause of the loose connector.
- 39 -
