Honeywell ADEMCO VISTA-48A, Installation And Setup Manual, Page: 46 / 80

Wireless Key Programming Templates
This procedure programs the wireless keys, but a key is not active until it is assigned to a user
number (see System Operation section, assigning attributes command).
If the D key was previously pressed (from *58 Menu mode) to enter and duplicate 5804 and/or
5804BD wireless keys, the following screens appear.
PROMPT VALID ENTRIES EXPLANATION
TEMPLATE ?
1–6 1
Template Number
1–3 = 5804 templates
4–6 = 5804BD templates
[
∗
] to continue
1. Enter Template number 1–6 (from next page).
See the defaults provided for each template in the chart that
follows these procedures.
2. Select from templates. Press [
∗
] to display template (1 shown
selected). NOTE : If necessary, press [#] to back up and re-enter
template number.
3. Press [#] if you want to return to zone attributes screen.
L 01 02 03 04
T 23 22 21 23
Template Display
[
∗
] to continue
4. When [
∗
] is pressed, the selected template will be displayed.
Top line of display represents loop numbers, bottom line
represents zone type assigned for each loop.
5. Press [
∗•
] to accept template.
PARTITION
1
Partition
1 = partition 1
2 = partition 2
3 = partition 3
[
∗
] to continue
6. Enter the partition in which the key is to be active.
7. Press [
∗
] to continue.
ENTER START ZONE
00 = QUIT 36
Start Zone Number
[
∗
] to continue
8. The system will search for the highest available consecutive 4-
zone group (the four zones in the case of the 5804 and 5804BD),
and display the lowest zone number of the group.
If you want to start at a different zone, enter the zone desired,
and press [
∗
]. If that zone number is displayed, the system has
the required number of consecutive zones available, beginning
with the zone you entered. If not, the system will again display a
suggested zone that can be used.
If the required number of consecutive zones is not available at all,
the system will display “00”.
9. Press [
∗
] to accept.
INPUT S/N L
AXXX-XXXX –
Serial Number
[
∗
] to continue
10. Manually enter the serial number printed on the label for the
wireless key or press and release the button to transmit its serial
number.
11. Press [
∗
] to accept the serial number. The system will check for
duplicate.
12. If necessary, press the [#] key to back up without saving, and re-
enter the serial number.
Use the [A] key to move forward within the screen, and the [B] key to
move backward.
XMIT TO CONFIRM
PRESS
∗
TO SKIP
Confirm
[
∗
] to continue
13. If “Yes” was entered at the SET TO CONFIRM? prompt
previously (see first prompt following entry into the
∗
58 Expert
Programming Mode), the display on the left will appear. Confirm
serial and loop numbers by activating the wireless key.
IMPORTANT:
When confirmed, the key is not active until it is assigned to a user
number (using the assigning attributes command, attribute “4”). See
System Operation section for procedure.
Installation Instructions
5-6