— 47 —
Output Devices Worksheets
Applicable only if relays (4204/4204CF) or V-Plex are used.
Output Devices
– Programmed in the #93 Menu Mode in the Output Programming Section. Fill in the required data on
the worksheet below and follow the procedure in the installation and setup guide as you enter the data during the
displays and prompts that appear in sequence.
NOTES:
1.
For 4204/4204CF, the Device Programming section must be programmed for the device address. Set the
DIP switches on the device for that address.
2.
For V-Plex, devices must be programmed in the Zone Programming section
3.
If you are using outputs on V-Plex (e.g., 4101SN) no more than 20 of the V-Plex outputs may be
programmed for the same START or STOP condition. Also, if you are using ZONE # for the START of a
V-Plex output and want that output to stop when the same zone restores, the STOP programming MUST
BE BLANK.
S T A R T
S T O P
OUTPUT
DEV #
A
EV/ZL
Zone
ZT / P
ZL
ZT / P
Relay
Group
Restrict
0=V-Plex
1=4204/
4204CF
V-Plex Zone #
or
Dev Add
4204/4204CF
Relay # for
4204/
4204CF
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Summary of Contents for Ademco VISTA-32FB
