Honeywell 4600g, User Manual

Page: 65 / 248

3 - 17
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low pri-
ority symbologies, you must set the time-out period. This is the period of time
the imager will search for a high priority barcode after a low priority barcode has
been encountered. Scan the barcode below, then set the delay (from 100-3,000
milliseconds) by scanning digits from the inside back cover, then scanning
Save . Default = 500 ms.
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default
values.
Output Sequence Overview
Require Output Sequence
When turned off, the barcode data will be output to the host as the Imager
decodes it. When turned on, all output data must conform to an edited
sequence or the imager will not transmit the output data to the host device.
Note: This selection is unavailable when Multiple Symbols (page 3-20) is
enabled.
Output Sequence Editor
This programming selection allows you to program the imager to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the barcodes are scanned. Reading
the
Default Sequence symbol programs the imager to the Universal values,
shown below. These are the defaults. Be certain you want to delete or clear all
formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you’ll need to know the code
I.D., code length, and character match(es) your application requires. Use
the Alphanumeric symbols (inside back cover) to read these options.
You must hold the trigger while reading each barcode in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see Require Output Sequence , page 3-
20).
2. Code I.D.
On the Symbology Chart on page A-1, find the symbology to which you want
Preferred Symbology Time-out
Preferred Symbology Default