Honeywell 4600g, User Manual

Page: 52 / 248

3 - 4
Trigger Modes
Manual/Serial Trigger
You can activate the imager either by pressing the trigger, or using a serial trig-
ger command (see
Trigger Commands on page 12-4). When in manual trigger
mode, the imager scans until a barcode is read, or until the trigger is released.
When in serial mode, the imager scans until a barcode has been read or until
the deactivate command is sent. The imager can also be set to turn itself off
after a specified time has elapsed (see
Read Time-Out , which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the imager’s trigger when
using serial commands to trigger the imager, or if the imager is in manual trigger
mode. Once the imager has timed out, you can activate the imager either by
pressing the trigger or using a serial trigger command. After scanning the
Read
Time-Out barcode, set the time-out duration (from 0-300,000 milliseconds) by
scanning digits from the inside back cover, then scanning Save . Default =
30,000.
Manual Trigger, Low Power
Note: Does not apply to the 4600r.
The imager powers down until the trigger is pulled. When the trigger is pulled,
the imager powers up and operates until there is no triggering for the time set
with the
Low Power Time-Out barcode below. There is a delay of up to one
second in operation when the imager is first triggered, but there is no delay
when operating in low power time-out mode.
Note: Manual Trigger, Low Power cannot be used with keyboard wedge
applications.
* Manual/Serial Trigger
Read Time-Out
Manual Trigger, Low Power