Honda HSM1380i, Owner'S Manual

Page: 118 / 130

116
SYMPTOM POSSIBLE CAUSE REMEDY
Snow discharge
chuter does not
throw snow well. (HSM1380i)
Engine is overloaded.
[Clearing in OFF mode] Lower the driving speed (see
page 74).
(HSM1390i)
Engine is overloaded.
[Clearing in SELF mode]
(HSM1380i)
Engine speed is too low.
[Clearing in OFF mode] Move the throttle control lever
to the ‘‘FAST’’ position (see
page 65).
(HSM1390i)
Engine speed is too low.
[Clearing in SELF or
POWER mode]
Blower is deformed. Replace the blower (see page 89).
Blower lock bolt is broken. Replace the blower lock bolt
(see page 88).
Auger lock bolt is broken. Replace the auger lock bolt (see
page 88).
Snow discharge chute is
angled down. Adjust so that the snow
discharge chute is angled up
(see page 30).
Auger runs up onto
and does not cut
into hard snow. Auger height is not proper. Adjust the auger height (see
page 53).
Auger housing
becomes clogged
with snow. Auger lock bolt is broken. Replace the auger lock bolt (see
page 88).
Auger is worn. Replace the auger (see page 89).
Blower lock bolt is broken. Replace the blower lock bolt
(see page 88).
The height of skid and
scraper is not proper. Adjust the skid and scraper (see
pages 50 through 52).
Auger is in contact
with the road
surface. Auger height is not
adjusted properly. Adjust the auger height (see
page 53).
Skid and scraper height is
not adjusted properly. Adjust the skid and scraper (see
pages 50 through 52).
Snowblowing
mechanism makes
an abnormal noise. The shape of the shaft and
wing of the auger and/or
blower is deformed. Consult an authorized Honda
dealer.
Chuter does not
rotate. Motor is overheated
(breaker tripped). Internal protection circuit is
armed when the auger power
height adjusting part is
overheated by frequent
application of the auger control
switch. Wait for a while and
operate the switch again.
Motor or switch is faulty. Consult an authorized Honda
dealer.
Right driver is faulty.
36V156410.book 116 ページ ２０１８年１０月１０日 水曜日 午前１１時３０分