© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27573 (0410)
21 of 22
74. Install the upper and lower unit brackets to the
receiver unit using two 4 x 8 mm washer-screws,
and two 4 mm flange nuts for each bracket.
75. Position the receiver unit between the right trunk
side panel and the rear fender panel, and plug in
the antenna cable connectors, the DIN cable
connector, and the XM radio harness connector
using the panel hole to access the receiver unit.
3619080M
XM RADIO
HARNESS
DIN CABLE
ANTENNA
CABLE
RECEIVER
UNIT
ANTENNA
CABLE
DIN
CABLE
XM RADIO
HARNESS
BLACK
CONNECTOR
3730020M
TRUNK SIDE
PANEL HOLE
240 mm
ANTENNA
CABLE
UPPER
UNIT
BRACKET
HOLE
–
= 240 mm
DIN CABLE
LOWER UNIT
BRACKET HOLE
WIRE
TIE
WITH
CLIP
WIRE TIE
WITH CLIPS (2)
76. Secure the antenna cable, the XM radio harness,
and the DIN cable with two wire ties with clip at
the measurement shown. Press the clips of the
wire ties into the trunk side panel hole and upper
unit bracket hole.
77. Fold the excess DIN cable, and secure it to the
lower unit bracket with one wire tie with clip.
78
Attach the receiver unit/brackets using two
6 x 12 mm washer-bolts through the trunk side
panel holes. Tighten the bolts securely.
3619092M
TRUNK SIDE
PANEL HOLE
6 x 12 mm
WASHER-
BOLT
6 x 12 mm
WASHER-
BOLTS (2)
3623031M
4 x 8 mm
WASHER-
SCREW
4 x 8 mm
WASHER-
SCREW
LOWER
UNIT
BRACKET
UPPER
UNIT
BRACKET
4 mm
FLANGE NUT
4 mm
FLANGE NUT
SCREW
POSITION
RECEIVER
UNIT
SCREW
POSITION
