MADRAX MADLOCKER ™ A
ssembly Instructions
MADRAX DIVISION
MLP-1
GRABER MANUFACTURING, INC.
10-3-18
Page 1 of 6
GENERAL INSTRUCTIONS
1.
Handle with care so that the painted surfaces are not marred.
2.
Leave all fasteners loose until instructed to tighten.
3.
Take care to not cross thread fasteners.
4.
All fasteners are ¼”
-
20 x ½” Stainless Steel Button Head Screws, except for the leveling
hardware and the hardware used to attach the lock handle.
TOOLS NEEDED
5/32” and 1/8” Hex Allen Wrenches
3/8” Open End Wrench
7/16” Open End Wrench
3/4” Open End W
rench
8” Adjustable Wrench
Straight Tip Screwdriver
Padding to protect painted surfaces during assembly
MATERIALS INCLUDED IN KIT
1/4
”
-20 x 1/2
” Button Head
3/8” x 5" Anchor Spikes
1/2
”
-13 Nut
1/2
”
-13 x 3 1/2
” Carriage Bolt
1/4
” Flat Fender Washer
1/4
”
-20 x 1" Button Head Socket Cap Screws
10-24 Nylon Nuts
10-24 x 3/4
” Tamper Resistant Screws
STEP 1
Assemble the
DOOR PANEL
with the
CAM AND LOCKING BAR ASSEMBLY
and the
LOCK AND
HANDLE ASSEMBLY
on a padded surface, face down. Allow the handle to extend over the edge
of a work surface for ease of assembly.
Insert the bottom lock bar first, then the top. See handle assembly illustrations below for order of
assembly. Assemble the appropriate handle with
10-24 x 3/4" Tamper Resistant Screws
and
10-
24 Nylon Nuts.
Padlock / U Lock Handle Assembly
Pop Out T Handle Assembly
