20 of 22
AII 27573 (0410)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
71. Attach one wire tie with clip to the antenna cable,
the XM radio harness and the DIN cable in the
area shown. Push the clip from the wire tie with
clip into the body hole.
72. Route the antenna cable, the XM radio harness,
and the DIN cable along the trunk side panel.
Loosely attach the three off-set wire ties with clip
around the antenna cable, the XM radio harness,
and the DIN cable, then push the clip from each
wire tie into the three holes in the trunk side panel.
3620060M
XM RADIO
HARNESS
ANTENNA
CABLE
DIN CABLE
WIRE TIE
WITH CLIP
BODY
HOLE
ANTENNA
CABLE
DIN CABLE
AND XM
RADIO
HARNESS
3620071M
OFF-SET WIRE
TIE WITH CLIP
(Note the installation
direction.)
PANEL EDGE
XM RADIO
HARNESS
ANTENNA
CABLE
DIN CABLE
OFF-SET
WIRE TIE WITH
CLIP (2)
(Note the
installation
direction.)
TRUNK SIDE
PANEL HOLE
TRUNK
SIDE
PANEL
TRUNK SIDE
PANEL HOLE
EPT SEALER
(Clean this
surface with
isopropyl
alcohol.)
73. Using isopropyl alcohol on a shop towel, clean the
bonding surface on the panel edge, attach one
EPT sealer to the panel edge in the area shown.