14 of 22
AII 27573 (0410)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
3618021M
3606052M
DISPLAY
MODULE UNIT
DISPLAY
MODULE
CABLE
(Pull out.)
REAR
42. Plug the display module cable into the FM
modulator unit. Pull the excess length of the cable
out from under the display module unit.
43. If equipped with a player, plug the BUS cable
connector into the vehicle connector.
45. Loop the excess display module cable along the
DIN cable and the vehicle harness, then secure
the display module cable, and the DIN cable with
one wire tie with clip. Insert the clip from the wire
tie into the modulator bracket hole.
46. Near the subbracket, secure the XM radio harness
to the vehicle harness with one wire tie.
47. Secure the excess length of DIN cable and
XM radio harness to the vehicle harness with two
wire ties.
48. If the vehicle is not equipped with a player, attach
the two grommet screws to the player panel in the
square holes as shown.
PLAYER BUS
CABLE
CONNECTOR
(If equipped.)
6 mm FLANGE
NUTS (4)
44. Install the display module assembly onto the
studs from the left and right player subbrackets,
and install the 6 mm flange nuts. Tighten the
flange nuts securely.
3606061M
WIRE TIE
WITH CLIP
DISPLAY MODULE
CABLE
XM RADIO
HARNESS
WIRE TIE
WIRE TIE
DIN CABLE
MODULATOR
BRACKET HOLE
2306131T
GROMMET SCREW
PLAYER
PANEL