Homewardbath M6028/6, Manual, Page: 7 / 15

6
Rev 06/2019
9. To install the temperature sensor, feel the cable thru the
panel. Push temperature sensor probe thru the temperature
sensor housing.
Note: use silicone on the locknut side of the
glass, so that the probe won’t fall out if someone presses on
it.
10. Install angle brackets over the installation holes of glass A,
connect with connector bolts (make the connection snug, but
loose enough to make adjustments.) Connector bolt caps will
be installed when final tightening is complete.
11. Mount the generator in your desired located. Connect water
line and control cable.
12. Connect and insulate the steam line.
13. Place bottom edge of glass A into the slot on the base as
shown. A small amount of soap or lubricant on the gaskets
will help with installation. Slide into top right-side gasket of
panel large back panel B.
14. Place glass D (top) on the top of the unit, align connecting
holes with glass D to glass panels A, B, and C. Use M6X10
connector bolt to connect. Note: Make sure the light wire is
hanging off to the control side. Please refer to illustration
below. Connect list wire to cable from cable.
15. Attach glass panel E which has a black stripe across the top
and side to glass panel D and A.
Note: On the front panel E
there is a “notch” o n the bottom. It is imperative the notch be
moved as far as the base will allow; this should give you an
overhang of the side panel over the base about 1/8 to 3/16 in.
If you do not have the glass positioned with the overhang
there will not be enough space between the door and the side
panel to enable the magnetic strips to make proper contact.