5
Rev 06/2019
INSTALLATION INSTRUCTIONS
Note: Confirm the drain setup.
1.
Place shower tray in the corner where it will be permanently
located. Note: The handing (R/L) of your unit determines
which side the 5in mounting plate/shelf goes (ie: A right
handed unit has the mounting plate/shelf on the right side).
2.
Determine placement of Steam Generator, water and electric
supply.
3.
In the parts box is a roll of a foam type tape with one side that
has an adhesive on it. This should be placed in the bottom
channels of the base where the glass panels rest.
4.
Install the corner gaskets on left and right sides of the large
back panel B, then install the angle bracket to the holes on
glass B (black back panel). Connect with screw.
Note: Attach
glass shelf brackets to back of panel B before proceeding.
5.
Install angle brackets to the glass panel (C). Install the angle
bracket to the holes on glass, panel C. Refer to picture below.
Note: Attach glass shelf brackets to back of panel C before
proceeding.
6.
Place glass C into the slot onto the base and insert into the
corner seal of glass B. Note: Glass B is the large black panel,
and glass C is a black side panel. Line up the installation
holes and connect glass B and glass C.
Note: Use Windex for
lubricant.
7.
Insert the half-moon shaped rubber seals onto the right side
(outside facing edge), and top edge of glass A. Note: top
gasket may be already installed on the panel
8.
To install the key pad, feed the control wire thru the hole of
the panel. Remove the cover paper at the bottom. To
achieve good adhesion effect, keep the sticking surface clean
and dry.
Summary of Contents for M6028/6
Page 11: ...10 Rev 06 2019 SCHEMATIC...