20
1/2 HP Chain Drive Garage Door Opener
Bell Wire
B) Install the Door Bell
1. Position the control console near the inside door into the garage. Approximately five feet above the
floor to keep out of the reach of small children.
2. Pull the insulation off the ends of the bell wire, then attach the two ends to the back side of the
console as shown.
3. Attach the door bell to the wall with two screws (M4 -20).
NOTE: Do not over-tighten the screw or you could damage the console.
This view is of the back
of the control console
Red (bell wire)
White (bell wire)