17
1/2 HP Chain Drive Garage Door Opener
A) Install Safety Sensors and Remote Switches
Installing the door sensors and remotes is done in three main steps:
A) Install the Safety Reversing Sensors
B) Install the Premium Control Console
C) Install the Keyless Entry Control Pad
Install the Safety Reversing Sensors
To avoid
injury
or
death
: Be sure to correctly install the safety sensors. Failure to correctly
install the safety sensors may result in malfunction of the emergency reverse system which can result in damage to
property, personal injury and death.
The garage door opener comes with two safety reversing sensors designed to stop the door from closing should
anything be in the way.
NOTES:
-The garage door will not operate unless the safety sensors are installed properly.
-When the invisible beam path is obstructed or misaligned while the door is closing, the door will reverse. If the
door is already open, it will not close. The door opener lights will flash.
Do the following to install the sensors.
1. Measure a point on the garage door wheel tracks six inches above the floor where the sensors will go:
Repeat on the other wheel track.