Homa Saniflux V Series, Original Instruction Manual

Page: 11 / 20

11
The voltage required in the technical data sheet
must correspond to the existing line voltage.
Make sure that the electrical installations are in ac-
cordance to electrical standard safety regulations applying
in your country.
The end of the pump power supply cable must not be
submerged in order to prevent water from penetrating
through the cable into the motor.The electrical connection
of the pump should be carried out in accordance with local
requirements and regulations.
The operating voltage and frequency are marked on the
pump and controller nameplates. Voltage tolerance : +6%
up to -10% of the voltage stated on the nameplates. Make
sure that the lifting station is suitable for the electricity
supply available at the installation site.
The lifting stations require no additional motor protection.
Connect the units to the mains supply.
7. Installation
The operator has to prevent damage through the
flooding of rooms caused by defects of the pump through
the use of appropriate measures (e.g. installation of alarm
units, backup pump or the like).
Install the disposal unit Saniflux V horizontal in the pre-
pared room of the front-wall installation on an even floor.
In order to allow low noise operation, the distance be-
tween the unit and the wall and the construction of the
front-wall installation should be 0,5 cm min.
To connect additional sanitary units (e.g. a shower) install
a DN 40 discharge hose from the outlet of the sanitary unit
to one of the inlets of the box. Please pay attention to give
the required gavity fall.
Please make sure that the front of the tank will not be
pressed in.
Remove the cap, which is screwed on the inlet and take
the black sealing ring and the white plastic ring out of the
cap.
Put the nut, the white plastic ring and the sealing ring onto
the DN 40 discharge pipe as shown above and put the
pipe into the inlet of the tank. Connect the discharge pipe
by tightening the nut to the inlet device. The black sealing
ring must be between the nut and the inlet device.
Please do the same in case you want to install any addi-
tional sanitary units.
To prevent a freezing of the discharge pipe please isolate
the complete discharge pipe up to the sewer level.
8. Start-Up
In combination with the pneumatic level control the pump
starts and stops according to the liquid level in the tank.
9. Maintenance and Repair
Before maintenance or repair disconnect the pump
from the power supply to avoid accidental starting of the
pump!
Before maintenance or repair make sure that all rotat-
ing parts stand still!
In case of a defect of the unit, a repair shall be carried
out only by the manufacturer or through an authorized
workshop. Conversions or alternations of the machine/unit
are permitted only after arrangement with the manufac-
turer. Only HOMA spare parts shall be used.
In accordance with the product liability law we point
out that we shall not be liable for damages caused by our
product due to unauthorized repair by persons other than
the manufacturer or an authorized workshop or due to the
use of spare parts other than original HOMA parts. The
same product liability limitations are valid for accessories.
Before carrying out maintenance and service, the
pump must be thoroughly flushed with clean water. Rinse
the pump parts in clean water after dismantling.
Pumps running under normal operation conditions should
be inspected at least once a year.
In accordance with DIN all connected sanitary appliances
must be installed in the same room as the pump.